Satel Integra Alarm Panel — Full Guide
How to configure Satel Integra for commercial installations, set up ETHM-1 IP monitoring, and integrate with KNX via the INT-KNX module.
Integra panel range
| Model | Zones | Outputs | Users | Partitions | Use |
|---|---|---|---|---|---|
| Integra 24 | 24 | 20 | 30 | 4 | Small residential |
| Integra 32 | 32 | 32 | 32 | 4 | Apartment, villa |
| Integra 64 | 64 | 64 | 64 | 8 | Commercial, hotel |
| Integra 128 | 128 | 128 | 255 | 32 | Large commercial |
| Integra 256+ | 256 | 256 | 256 | 32 | Campus, hospital |
Zones can be expanded with INT-E, INT-ADR expander modules. Zones are physical wired inputs (NO/NC contacts + resistors for EOL supervision).
Zone types in Integra
Each zone is individually configured in DLOAD10 software. Key zone types:
Zone disabled
Zone triggers alarm after entry delay — for door detectors with entry route
Combined entry and exit delay zone
Immediate alarm — for internal PIRs, glass break detectors
Triggers alarm in Stay (home armed) mode — for external beams, door contacts
Active regardless of arm status — tamper protection
Always active — fire detector input
Silent or audible panic — panic button input
Technical alarm — water leak, temperature, power failure
ETHM-1 Plus — IP monitoring and remote access
The ETHM-1 Plus module adds Ethernet connectivity to any Integra panel:
- →INTEGRA CONTROL app (iOS/Android) — arm/disarm, zone status, event log
- →DLOAD10 over IP — remote programming without visiting the site
- →IP monitoring — Contact ID or SIA protocol to monitoring station over TCP/IP
- →HTTP API — webhooks to home automation systems (Fibaro, Loxone, Home Assistant)
- →SATEL Cloud — encrypted remote access without port forwarding
INT-KNX — native KNX integration
The INT-KNX module connects Satel Integra directly to the KNX TP bus. This is the cleanest KNX integration available for any alarm panel:
INT-KNX acts as a KNX device on the TP bus — appears in ETS as a standard KNX device
Maps Integra zone states to KNX group addresses: motion detected → KNX 1-bit value
Maps arm/disarm to KNX: arm-away command from KNX → Integra arms partition
Maps outputs to KNX: Integra relay output → KNX status group address
Maps Integra alarms to KNX: intrusion alarm → KNX 1-bit alarm flag for visualisation
All mapping configured in DLOAD10 + ETS — no third-party server required
With INT-KNX, the KNX system can: trigger lighting scenes on intrusion detection, show zone status on KNX touch panels, arm/disarm the alarm when the last person leaves via KNX presence logic, and integrate alarm events into energy management reporting.
Satel Integra + KNX integration
INT-KNX module configured, ETS group addresses mapped, alarm/KNX scenes commissioned. Part of our security panel service.
Request a quote →